Dodge Viper Steering Rack Bushings (Gen 1, 2, 3, 4, 5)

Aluminum, light weight, coated steering rack bushings for Gen 2, 3, 4, and 5 Dodge Vipers. This is for a set of 4 for 1 steering rack.

• The OEM/factory insulator bushings are rubber and can wear out, dry rot, and even melt over time, especially under hard use.
• In these particular cars, NVH (noise, vibration, harshness) isn't increased too much with aluminum bushings, and steering response and precision is greatly improved.
• These replacement rack bushings are made of aluminum, with an anodized coating to prevent the galvanic corrosion that can occur when using bare aluminum bushings in the steering rack hole that is steel (1 hole is steel and 1 hole is aluminum on Viper racks).
• Lightening holes have been added to achieve less mass compared to a simple solid bushing.
• Designed with a light press-fit into a good condition rack, to avoid excess steering rack wear from the bushing not fitting in the rack mounting hole tightly enough.
  

Compatible with:

Gen 1 (SR I) (1991-1995) Dodge Viper RT/10

Gen 2 (SR II) 1996-2002 Dodge Viper RT/10, GTS, ACR

Gen 3 (ZB I) 2003-2006 Dodge Viper SRT-10, ACR

Gen 4 (ZB II) 2008-2010 Dodge Viper SRT-10, ACR

Gen 5 (VX I) 2013-2017 Dodge or SRT Viper SRT-10, ACR

Included parts:

1 set (4 pcs) steering rack bushings

Detailed instructions

Recommendations:

Inspect and replace the inner and outer tie rods and steering rack bump stops (available here: https://www.revzerors.com/products/dodge-viper-steering-rack-bump-stops) if needed

Inspect and send the steering rack for a rebuild if there is excess backlash/play or fluid leakage -- contact us for rebuilder suggestions.